Home made throttle holders

Several years ago I bought a couple of these throttle holders from a local shop and have really liked them.  These are designed to fit the throttles from several different DCC manufacturers.




The layout as grown to the point that I wanted some more but they don't seem to be in shops any more and on line they are now about $15.00 each which is quite a bit more than what I had paid before so I started looking at making my own using scraps.  It needed to be simple and only had to work with Digitrax throttles.

The design I came up with uses 6 scraps of 1/4 inch plywood and tempered hard board shown here.  These are the pieces and sizes.

1 Hard board back 4.25" x 3.00"
2 Hard board fronts 4.25" x .562"
1 Plywood bottom 3.00" x 1.00"
2 Plywood sides 4.00" x 1.00"

Here is the throttle holder after being assembled with yellow carpenters glue and sanded.   I rounded the top corners on the front strips before assembly.   There are a couple of mounting holes in the back which can't be seen in this photo because of the throttle.

I test fitted several types of Digitrax throttles and they all fit nicely.  I don't know if this would work with throttles of other DCC brands.





I like these home made holders well enough that I may make these standard for the home layout as they will all look the same.  Then adapt the other holders for use on the Ntrak modules.