Land forms for the Golconda section

After finishing the basic bench work I used a similar method as I had done on the Wesso section to create the contours of the land.  Insulation board was cut and shaped with a inexpensive steak knife to get the basic shapes I wanted.  This time I decided to place a layer of plaster cloth over the shaped insulation board to further refine the shapes.  This will later be followed up with a brushed on wet coat of sheet rock mud.

The bridge abutments were cut from 1/4 inch plastic and after fitting them into the correct positions were attached with Liquid Nails adhesive.  The masking tape is to protect them from getting any plaster or sheet rock mud on them.